PRE-CONSTRUCTION BIM
Concept Design
We are providing our fire protection, fire alarm systems with MEP Engineering & BIM services globally to our customers from owner, architect, consulting engineers, design build contractor, general contractors, sub- contractors including facility management team. We have listed standard codes practice for Fire system design.
| USA | NFPA |
| CANADA | NFC, NFPA |
| AUSTRAILIA | NEW ZEALAND | AS/NZS 3000, AS 1670 |
| UNITED KINGDOM | IRELAND | EUROPE | BS 9251, BS 59839, BS EN 12848, EN 54 |
| SINGAPORE |MALYSIA | SEA | CP 52, SS 645, MS 1743, MS 1910, NFPA |
| UAE | SAUDI | QUTAR | GULF | DBC, SBC, QCS, NFPA |
| INDIA | NBC, IS 2189 |
At this stage our Fire designer starts the works with basic consideration of fire protections systems like as follows.
Fire Protection
Fire Alarm
Detail Design
Once's we receive the approval on the concept design we detailed the networks piping and networking of sprinkler systems.
Following we are MEP detailed use to covered:
Design 3D Model (LOD 300)
We have a team fire 3D modeler works on 3D models i. e. Fire Hydrant, sprinkler, extinguishers, fire alarm, detection systems fixtures, piping, fitting with all accessories & associated equipment's.
We produce 3D Models based on design schematic, basic plans, engineering markups to produce the fire protection systems 3D model with the proper Sizes & details.
Design | Tender | Contract Drawing
After completion of 3D model, we create sheet template with proper title block and start working on the production of design drawing with proper annotation and dimensions.
Design drawing set will have following list of drawing.
CONSTRUCTION BIM
Construction 3D Model (LOD 400)
We specialize in the virtual construction of 3D BIM model of Fire protection and fire alarm systems @ LOD 400.
Based on the tender drawing & specifications, we use to produce the model for firefighting networks, sprinklers, Extinguishers, hydrants for fire protections systems.
For fire alarm, we use to produce the model for fire alarm fixtures based on the approved fire fixtures.
Equipment Modelling
From the manufacturer’s 2D drawings, and in line with project specifications, we create a 3D model of all fire networks equipment's like pump, extinguisher, hydrant box, fire alarm panel.
BIM Co-Ordination
We generate a coordinated BIM model after resolving the clashes among all disciplines – Architectural, Structural, Concrete, Mechanical, Electrical, Plumbing, Fire Protection, etc.
First we identify the clash and create a view points level wise or Zone wise as per schedule and working on resolution internally. If we found any critical clash, we use to generate report and to co-ordinate with the all stakeholders and providing optimize solution to complete. Once all the clashes has been resolved, we make the final model for next stage to produce the shop drawing and As built drawing.
BIM DRAWINGS
Shop Drawing
BIM is highly useful for contractors, fabricators, suppliers, and manufacturers during construction of any irregular or complex project to generate accurate shop drawings.
Utilizing a coordinated project BIM model, we generate accurate shop drawings that are detailed enough for workshop fabrication and/or on- site construction.
Shop Drawing produced with proper dimension, annotation, COP, BOP inline with client standard, sample and requirement as per standard practice.
AS BUILT BIM
Built Model & Drawing (LOD – 500)
After Installation of fire protection and fire alarm systems based on BIM drawings, Site team use to mark-ups the updates and changes in the plans based on the actual installation in site. Based on the site mark-ups, we create as built 3D model & Drawing and prepare the as built set for project hand over and record.
