Design 3D Model (LOD 300)

We are specialize to develop design 3D models of mechanical | HVAC system including AC ducting, ventilation, piping networks with duct, fitting & accessories, pipe fitting & accessories. We produce 3D Models based on the mark ups, schematic, concept design and reference plans to complete 3D model.

Design | Tender | Contract Drawing

Based on the mark-ups, reference drawing, we produce the design drawing for mechanical systems once the design 3D model will be completed, we produce the complete design drawings /Tender Drawing / permit, contract drawing sets with proper annotation, tag with proper schedule to finalize the design drawing sets.

Design drawing set will have following list of drawings

• Legend, Notes & Specification
• Floor Plans
• Schematic / Isometric
• Detail Sheet
• Schedule

Construction 3D Model (LOD 350 & 400)

We are specialize in the virtual construction of 3D models @ LOD 400 of mechanical systems i.e. ducting, piping with fitting including all valves & accessories with all associated equipment’s and fixtures.

We produce 3D Models based on contract drawings, technical specifications, and manufacturer details to client standards to complete the construction model.

Equipment Modeling

From the manufacturer’s 2D drawings and inline with Mechanical schedules, we create a 3D model of all the Mechanical equipment such as PUMPS, AHU, RTU, CU, FCU, VAV, pumps, chiller fans.

BIM Co-Ordination

We generate a coordinated BIM model after resolving the clashes among all disciplines – Architectural, Structural, Concrete, Mechanical, Electrical, Plumbing, Fire Protection, etc.

First we identify the clash and create a view points level wise or Zone wise as per schedule and working on resolution internally. If we found any critical clash, we use to generate report and to co-ordinate with the all stakeholders and providing optimize solution to complete. Once all the clashes has been resolved, we make the final model for next stage to produce the shop drawing and As built drawing.

Penetration | Builder works Drawing

Penetration drawings are created from the coordinated BIM model after alignment with the architectural grids and penetration drawings are required before a contractor can start pouring concrete on the site. Our experienced team keeps the necessary clearances for the penetration as per the contract documents and Specification.

Shop Drawing

BIM is highly useful for contractors, fabricators, suppliers, and manufacturers during construction of any irregular or complex project to generate accurate shop drawings.

Utilizing a coordinated project BIM model, we generate accurate shop drawings that are detailed enough for workshop fabrication and/or on-site construction.

Shop Drawing produced with proper dimension, annotation, BOD, COP & BOP inline with client standard, sample and requirement as per standard practice.

Spool Drawing

D & D produce the Spool drawings after the co-ordination of model. We design the spool template based on the standard practice for spool isometrics and material, accessories scheduling to complete the spool layouts. Our experience team is well trained to generate spool drawing as per standard practice and client requirements.

Hanger & Insert Drawing

D & D produce the   Hanger & insert drawing with proper co-ordination of model and placing the hangers in line with specification. Hanger drawings shows the actual location of hangers with proper dimension from wall or grid. Insert are position of hangers insert points and D & D produce the proper insert drawing coordinating with actual hanger location in the model